Australian material tools

Paver Calculator Australia

Estimate paving area, paver quantity, waste allowance, optional packs and indicative material cost from metric dimensions.

Paving dimensions

Enter a rectangular area or your total paving area directly. Use the actual paver face size and supplier pack coverage where available.

metres (m)

metres (m)

quantity

percent (%)

millimetres (mm)

millimetres (mm)

m² per pack — use supplier figure

AUD per pack

Paver estimate

Results update as you change the inputs.

Total paving area18.00 m²
Single paver area0.080 m²
Pavers before waste225 pavers
Pavers including waste241 pavers
Required area including waste19.26 m²
Outside perimeter18.00 m
Estimated packs—
Estimated paver cost—
Supplier check: pavers are often sold by pack, layer or square metre. For purchasing, the supplier’s stated pack coverage is usually more useful than relying only on nominal paver dimensions.

Worked example: paving a 6 m × 3 m area

A rectangular 6 m × 3 m paving area equals 18.00 m², with a perimeter of 18.00 m. A nominal 400 × 200 mm paver covers 0.4 × 0.2 = 0.080 m², so the area-only estimate is 225 pavers. Including 7% waste, the allowance area becomes 18 × 1.07 = 19.26 m², or 241 pavers rounded up.

This simplified approach does not automatically deduct joint spacing or adjust for a specific paving pattern, border courses, cuts, curves or drainage falls. Supplier pack coverage may include joint assumptions, so confirm the manufacturer’s take-off method before ordering. Pavers are different from floor tiles; use the tile calculator when estimating indoor tile quantities.

How the paver calculation works

Area = length × width × quantity
Single paver area = paver length × paver width after converting mm to metres
Paver quantity = required area ÷ single paver area, rounded up

SiteSum applies your waste allowance to the paving area before calculating the final whole-paver quantity. Use a waste percentage that reflects cuts, pattern, breakage and project shape.

Paver calculator FAQs

Can I use this for a driveway?

Yes for preliminary paver quantities. The calculator does not design pavement thickness, sub-base, drainage or edge restraint. Confirm those requirements for your site and intended loading.

Does joint width affect the result?

This planning calculator uses the paver face dimensions and your waste allowance. For ordering, supplier coverage per pack or per square metre is the better purchasing reference when available.

What waste allowance should I use?

Waste varies with layout, paver size, cuts, pattern and site geometry. Increase the allowance for irregular areas or complex patterns and confirm with your installer or supplier.

Browse more SiteSum material calculators →

Planning estimate only: verify actual paver dimensions, pack coverage, layout, site measurements, waste and current supplier pricing before purchasing materials.