Australian roofing tools

Roof Pitch Calculator Australia

Calculate roof pitch in degrees, slope percentage, rise per metre, pitch ratio, rafter length and approximate roof area using metric inputs.

Enter roof dimensions

Rise and run determine the pitch. Building width and length are optional and are used to estimate area for a simple symmetrical gable roof.

millimetres (mm)
horizontal run, mm
metres (m)
metres (m)
percent (%)

Results

Results update as you change the values.

Roof pitch—
Slope—
Rise per metre—
Pitch ratio (rise : run)—
Rafter length for entered run—
Slope factor—
Approx. roof area—
Enter building width and length to calculate area.
run rise —

Area assumes a simple symmetrical gable roof with no allowance for eaves, valleys, hips, dormers or penetrations. Waste is applied separately.

How the roof pitch calculator works

Roof pitch is the angle formed by the roof surface relative to horizontal. Enter the vertical rise and horizontal run using the same unit. SiteSum converts that relationship into degrees, percentage slope and a rise-to-run ratio.

Pitch angle: θ = arctan(rise ÷ run)
Slope: (rise ÷ run) × 100
Slope factor: √(rise² + run²) ÷ run

Roof pitch conversion chart: degrees, slope and rise per metre

For a roof with a measured pitch in degrees, these conversions give the vertical rise for every 1,000 mm of horizontal run. The slope factor converts horizontal plan area into approximate sloping roof area for a simple roof plane.

PitchSlopeRise per metreArea factor
5°8.7%87 mm1.004
10°17.6%176 mm1.015
15°26.8%268 mm1.035
22.5°41.4%414 mm1.082
30°57.7%577 mm1.155
35°70.0%700 mm1.221

Example from the calculator: a 600 mm rise over a 2,400 mm horizontal run gives a 25% slope, approximately 14.0° and a roof-area factor of 1.031. A 4-in-12 pitch (often seen in US materials) means 4 units of rise for 12 units of horizontal run: arctan(4 ÷ 12) ≈ 18.4°. These pitch ratios must not be confused with the full roof span.

Roofing-system suitability is product-specific. For example, LYSAGHT’s roof-pitch guidance describes CUSTOM ORB® corrugated steel down to 5° and TRIMDEK® down to 2°, subject to the relevant product and installation details. Do not use a general pitch chart alone to choose sheet, tile or waterproofing systems.

Roof area estimate

If you enter building width and length, the calculator estimates the sloping surface area of a simple symmetrical gable roof using the slope factor. The optional waste allowance is then added to help with early material planning.

Approximate gable roof area = building width × building length × slope factor.

Roof pitch FAQs

What is the difference between rise and run?

Rise is the vertical change in height. Run is the horizontal distance over which that rise occurs. For a symmetrical gable roof, the run from outside wall to ridge is commonly about half the building span, excluding overhangs.

Does this calculator tell me whether a roofing product is suitable for my pitch?

No. Minimum roof pitch depends on the specific roofing system, profile, installation details and manufacturer requirements. Check the current product documentation and relevant project requirements before specifying materials.

Is the calculated roof area exact?

No. It is an early estimate for a simple gable roof. Real roofs may include eaves, hips, valleys, gutters, penetrations, dormers and other geometry that changes the measured area.

Planning estimate only: SiteSum calculators are intended for preliminary estimating and checking. They do not replace project-specific measurements, manufacturer requirements, engineering design or professional advice.

Related SiteSum tools: compare this result with the Roof Replacement Cost Calculator, or browse the Roofing Calculators hub.